I have noticed that my home server is strangely using lots of swap (~5 GB), despite having only a few lightweight processes running and loads of RAM installed (32 GB).

Upon configuring Grafana + Prometheus, I noticed a trend where cache + buffer will progressively increase until swap starts to be used. My system and services combined will use ~8 GB RAM. Upon rebooting, the cache + buffer will start anywhere from 3–10 GB, progressively ramp up to ~25 GB in 1–2h, where swap will start to be needed (~3 GB). See the image attached for reference.

My swap filesystem is on an expensive (to me) SSD, and I would like to reduce its wear by as much as possible. I understand that swap can introduce only minimal wear on SSDs depending on its nature and that it can be harmless, but I am still not sure what is causing this behavior (and why) and whether I should worry about it or not. So I figured I should investigate what is happening here.

My main question is, how can I figure out what is causing this behavior? Is it expected? I am looking for guidance from others who are more experienced than me in the topic.

A little bit about my system:

I am running Debian 12 on an NVMe SSD containing the root partition (btrfs) and docker services. I also have two HDDs, one with persistent data (ext4), and the other with backups (ext4). This is majoritarily a single-user machine. I tried using the following kernel parameters, but it hasn’t helped:

vm.swappiness=10
vm.vfs_cache_pressure=200

My docker services are:

  • *arr stack
  • jellyfin
  • nextcloud
  • immich
  • open-webui + ollama
  • pi-hole
  • invidious
  • romm
  • nginx proxy manager
  • grafana + prometheus
  • other minor services that I don’t think are doing much (uptime-kuma, stirlingpdf, vaultwarden, etc)
  • Overspark@piefed.socialEnglish
    9·
    3 hours ago

    Yeah that’s completely normal, looks absolutely fine to me. For more info on how linux uses memory I suggest reading https://www.linuxatemyram.com/

    To add: that link suggests looking if your swap usage is changing. Linux is quite happy to stuff some memory that isn’t actually used in swap. If it was right about it not being used you should see the swap usage not changing much, so your SSD isn’t really being used either apart from the initial swap-out. If your swap usage keeps fluctuating wildly there is more going on which might warrant further investigation.